Electrical technology
7.5 ECTS creditsThe course deals with the following components:
Electrical circuits: calculation with Ohm's and Kirchoff's laws of series and parallel circuits, Thevenin's theorem
Single and three-phase alternating currents: definitions of sinusoidal voltage and currents, using phasor diagram and the j-omega method, Y- and D-connected three-phase systems
Power: active, reactive and apparent power, phase compensation
Transformer: windings-, voltage- and current ratio, transformer formula
Non-synchronous machine: design, moment, rotational speed, slip, loss and efficiency, Y and D connected machine, frequency regulation
Synchronous machine, servo-motor, stepping motor: design, function and application areas
Direct current machine: design, separate and series magnetized machine, moment, rotational speed, loss and efficiency.
Electrical circuits: calculation with Ohm's and Kirchoff's laws of series and parallel circuits, Thevenin's theorem
Single and three-phase alternating currents: definitions of sinusoidal voltage and currents, using phasor diagram and the j-omega method, Y- and D-connected three-phase systems
Power: active, reactive and apparent power, phase compensation
Transformer: windings-, voltage- and current ratio, transformer formula
Non-synchronous machine: design, moment, rotational speed, slip, loss and efficiency, Y and D connected machine, frequency regulation
Synchronous machine, servo-motor, stepping motor: design, function and application areas
Direct current machine: design, separate and series magnetized machine, moment, rotational speed, loss and efficiency.
Progressive specialisation:
G1F (has less than 60 credits in first鈥恈ycle course/s as entry requirements)
Education level:
Undergraduate level
Admission requirements
Mathematics for engineers I, 7.5 ECTS cr or admission to the programme TGHMT or TGHID, or equivalent.
Selection:
Selection is usually based on your grade point average from upper secondary school or the number of credit points from previous university studies, or both.
This course is included in the following programme
- Study Programme in Innovation and Design Engineering (studied during year 2)
- Study Programme in Mechanical Engineering (studied during year 2)